...
High quality bearings and unique thrust bearings shown here going into these new very robust blade grips.
Ballraced mixer arms are installed here. Grease bearings before install.
...
Brass
shims used here, just slid it up to position and bolt on grip. Make
sure you use red locktite here and clean
surafaces
with alky or acetone so locktite can do it's job. The rotorhead is lookiing
very solid here!
...
Rotor
brake comes as standard in Uni-2000 kits. Fully ballraced flybar rocker
shown here, simple and efficient.
...
Bearings
installed in head with 2 mm screw to retain bearing face. Control bridge
components shown here ready
to
go together.
..
Here
is the bridge piece installed along with pitch compensator guide pins.They
are installed with a little 603-
locktite
and taped into place.
Page
1
Page
2
Page
3
Page
4
Page
5
Page
6
Page
7
Page
8
Page
9
© copyright 2003 V-EAST.
Any reproduction \copy of the images or text on this website is strictly prohibited.V-East
P.O Box 35-7684
Gainesville, Fl
U.S.A
32635-7684
352-371-3132 ph.