...
Although it's not needed, I add a shim under the annular clamp on main bearing to serve as a cover for bearing.
Here you can see the leak-proof set up that the fuel system provides. Brass ring acts a reinforcement for tank neck.
Fuel line and filter is included with kit as standard.
...
The
lower frame is simple in its construction . I like to use 5 min epoxy as
gasket for manifold, it works great! Here
you
can see the units mated, Some small amount of matierial must be removed
on shroud to clear exhaust path.
Also
shown is optional tail pipe in s.s. for use with 2240 muffler. I chose
this muffler since it works well with this
displacement
motor and fits great in any fuse.... the compact one shown earlier is really
for use with rear exhaust
motors.
...
These
shots illustrate just how slim and compact this system is. Light weight,
no exhaust to contend with
(hangers,
etc...)clean and simple with TOP START and FOWARD C.G. enhanced! Windshield
panel pops out to
allow
full boom and pushrod to installed without have to disassemble anything!
...
.
Here
is a full shot of all compnents together, check out this neat switch and
fuel mount that bolts to side of system,
promoteing
a cleaner, more moduar install.
...
Gyro
plate added here and now we move onto fully ballraced pitch compensator.
Page 1
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
© copyright 2003 V-EAST.
Any reproduction \copy of the images or text on this website is strictly prohibited.V-East
P.O Box 35-7684
Gainesville, Fl
U.S.A
32635-7684
352-371-3132 ph.