...
.
Split second stage gear to allow for driven tail during autorotations. Use 242 on bolts for these and make sure pin
is all the way down into hub before adding second half of gear,also grease shim inbetween these two parts as well.
Again here work slowly , you may have to rotate bearing blocks to get the perfect mesh, approx .5mm gap.
..
This
is what it should look like when its all done, remember to thourghly clean
the end of main shaft top and bottom
for
alu-annlular clamps.
...
Alu-
clutch, fully ballraced with fan shown here, either a Pegae or Heim start
adaptor can
be
used to secure fan. The O.S. .91 FX-HGL motor is a heli- only motor producing
approx
3.2
hp, is tolerant on nitro use, and is ringed for smooth running and starts.No
break- in
needed
other than 2 or 3 tanks taking it easy.
Go here to see detailed installation tips on clutch installation.
...
Just
had to show these and just big this puppy is! It is well FOWARD of the
main shaft and balance out very nice
in
any model.Top start is great too and Heim is LEGENDARY for their cooling.
...
Just
a quick mock-up of exhaust route, centered, with great c.g. and secure
bracket for mechs.
clean
and simple, more on this later. Now its on to the super structure and fuel
tank.
Very
beefy shrould and components and neat switch and plug bracket, far right.
STAY
tuned!