...
This bevel ring helps the boom and coupler find center when going together so the wire
drive does not hang up while trying to slide it in from behind! After we find the right
length for wire we grind one flat on to the end... set in with 608 locktite.
...
Screw
tail housing in place with some 608 on screws, rotate boom with you get
about
1700
mm of a level surface and you know you are right on the boom. Once you
do that
safety
screw the boom to holder and tail box to boom.
...
Here
is how it looks, different ... true... change is good!
This
curved boom can be swapped with a straight one anytime.
Its
really for novice flyers.
Aluminum
boom supports are Very strong and should keep the tail good and solid!
...
Safety
screw on box. Angle finder is used for a lot of tasks.....
...
Tail
rotor push rod runs through carbon shaft and is very simple and free running.
A
ball link could be easily added later of even a carbon push rod kit.