STARLET50 Build-up
Scale Ready Pod and Boom Kit complete with Motor and Silencer. page 3
...
.
Lower frame ready for attachment to uppers. Assembly is easy and straightforward.
...
Fuel
tank is simple and easy ,14 oz. should be more than sufficient, we may
add
a
2 oz. header tank later . That little white thing is a fuel filter to keep
pressure charge
clean
and from fouling the tank. Any filter will do.
...
Muffler
is installed here, clean simple and light. Any other system may be used
also.
Thread/bearing
seating compound used to glue pins in mixer base. The only safe
thing
to use besides slo-ca glue.
...
Mixer
is installed, use appropriate amount of shims on arms to produce a free
moving
assemble
without binding. Alu-swashplate shown as upgrade over alu-composite
unit.
I prefer the all-alu unit over stock. The all-alu unit is a low cost upgrade.
...
Thos
brass bushes are glued to bolts using 608 and or course can be upgraded
later
to full ball bearing units if so desired. These ball/thrust races are super
robust,
capped
off with top after you set the balls in place with grease. Care must taken
here.
work
slow. Clean shaft for locktite along with 5 mm bolts.