STARLET50 Build-up
Scale Ready Pod and Boom Kit complete with Motor and Silencer. page 2
...
Here we have the main transmission going together.. it is important that you check
bearing block positions before setting bearings with bearing lock 608.
Clean all bolts before use with alky so locktite can do its job.
...
Main
shaft pin located here. Instructions are clear and concise. At this stage
we
are putting the two frame half's together checking for free rotation with
no binding.
If
there is some binding, rotate bearing blocks 180 degrees and that should
eliminate it.
...
Motor
parts laid out ready for install, washer goes like this.
...
.
Finished
motor and clutch, ball goes on outer hole of throttle arm. Upgradeable
to .61-91 power.(91 shown)
...
Mounts
installed like this, special bolts go on top. Lowers get added later.