...
Radar dome and electronics compartment breather vent...
D
...
Airspeed
tubes are now removeable, thanks to my cat!
... 
Fuel filler caps
made from brass tubes.. small pieces are "sleeved" then
caped at once
during the solder process.. then they are ground down to this.
then carefully heated platesaccept a drop of solder to pin them down onto
plates.
Small balsa strips
will hold filler caps into recessed position while jb weld dries.
We just need
to rivets and add chains after paint.
F
....
...
Step plates are
modifed since i didnt have doc. pics on this at the time.
They now work
correctly.
.
...
Grey ABS plastic
sheet used to create inner panels since they dont require
primer to smooth
out. X marks where the small wire hinge is, alu sleeve
acts as bearing.Jb
welded into place after the area was sanded.
.... 
Again, abs sheet
used to creat locker panel...
A small carving
from bass wood. Before and after...