Presents: Bell 230 UT online support build-up. Page 11
.....
Starter
access door with Graupner latch 4260.12 , it can be molded or shaped into
your installation very easily. If I
used a magnet, I would need a tool to open it each time.
This heli is user friendly!
..
The new landing light kit...
flush mounts on the inside.
'
......
A keyhole shaped hole is cut
in the floor and the light fixture can be gooped into
place after the apint work is complete. Here
the light is tacked in for fitting and is in
the fully retracted position.
......
I will use a micro servo
up front to control this light, a servo mounted micro switch
will take of the light switching on only in
the down position. This helicopter is just about
done and ready to paint... She has hours of
flying her now and everything is just as it
was off the bench. The inside is still clean
and after 3 models and hours upon hours
of flight testing, the mechanics show no wear
whatsoever.
off to the paint booth!
This is what I am going for....Hot Tamele'
I will spice up
the color using porshe red.
© copyright 2000 V-EAST.
Any reproduction \copy of the images or text on this website is strictly prohibited.V- East
P.O Box 35-7684
Gainesville, Fl
U.S.A
32635-7684
352-371-3132 ph.