...
After the glue is dry , Its time to install the front unit... I use jb weld to glue in the bushings
and then slide in the unit from one side as I set the arm with pin in.
...
The finished
unit , following the instructions for the right angles . SInce this is the
only
wing
brace, I tossed in a little carbon strand to make them all they can be.
...
Futaba
3001 ball bearing servos used and installed here, first we tack the brackets
with
c/a then once all is good, we glue em in...pre-sanding the area is needed
.
The front
servo and wood set installed and a correct angles, set screws are locked
in once
we have them adjusted with the mains... we want all the retracts to work
without
servo
stalling and for them to lock into positions properly, you may have to play
with
induvidual
rod lengths to achieve this... it's not to difficult as it took me about
30 min
to get them all square.
...
BAll
glued up and ready for rear plate for floor and upper supports... doner mechs
in waiting...
I am gonna use a NEW version Uni-2000 LN system with the new
O.S.
91 FX-HG motors we now stock. 3.1 hp in this little thing? you bethca!
...
I chose
to beef up the spacer blocks... Upper mounts dry fitted.
Set to
dry on smoth flat surface...
Page 1 Page 2 Page
3
Page 4 Page
5 Page 6
Page 7 Page
8 Page 9
Page 10 Page 11
Page 12
Page 13 Page 14 Extra
details Here...