Turbine NH-90
On-line support Build-up / Page 3
Turbine Q&A/Addtional support products section here.
Corrections and Addendums here.
...
Ok, with the test fit comes the next step
and that is to mark off all the areas that the wood touches the fuse. I
then sand all
of those marked areas with 60-80 grit paper then
again wash out the fuse with clean water to remove all sanding dust and
to clear the "pores" of the sanded areas for
maximum adhesion. The wood kit is assembled without the two front stub-bulk-
heads on a flat surface with heavy weight on
it check that all is square and correct we then apply thin CA glue first,
followed
by beads of thick CA glue later (a few hours).
the whole thing is done on wax paper and let to dry 'til the next day.
Do not use
kicker here or in the fuse.
...
Once dry the wood is fitted back into the fuse
the glued in place using thin CA first, followed by thick later. You can
see how the CA "wicks" into the grain of the
wood for superior bond, it also does this within the glass.
...
Next we can install the bulkhead
for the servo taking to orient it correctly as per drawing.The bell cranks
are then cut on
one side to create the retract lever. Use a 2
mm and 3 mm tap to tap the holes first!
...
I will wait to glue these blocks
in until i have the servos in just be sure, this is what the completed
arm should look like.
Next: cut the 3 mm threaded section of rods down
to total length of 128 mm . With the ball ends on, the total length should
be 157 mm.
..
A better view of the completed assembly , a quick
test fit and the servos install next...
..
At this point I install the front bulkheads again
showing glue I added some alu-tube to sleeve the strut
for
penetration. Next we install the retract servos
and finalize a more scale appearance.
that installation.
| Page 1
Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 Page 8 Page 9 |
Page 10
Page 11 Page 12 Page 13 Page 14 Page 15 Page 16 Page 17 Page 18 |
© copyright 2000 V-EAST.
Any reproduction \copy of the images or text on this web site is strictly prohibited.
V-East
P.O Box 35-7684
Gainesville, Fl
U.S.A
32635-7684
352-371-3132 ph.